Connect The Lamp Power Supply (Lps) - Christie CP4230 User Manual

Section 2: Installation and Setup

2.15 Connect the Lamp Power Supply (LPS)

connected to the cathode lead and the red (+) power cable must be connected to the anode
lead. Reversing the connections can damage the projector.
WARNING
WARNING
safety. Never compromise safety by returning the current through the ground. 3) Connect
ground FIRST to reduce shock hazard.
WARNING WARNING
the cable from rubbing against the LPS knockout plate and becoming damaged.
As shipped
200V
Power Connectors (optional)
Must terminate the power connector terminal
block correctly to ensure 200VAC-240VAC
output. Line cord provided for connection
to projector only.
Power Connector Breaker
(On = up position)
1. Connect the LPS Communication Cables:
a. Remove the 2 cover plate thumbscrews from the projector's baseplate in the LVPS compartment.
b. Connect one end of the RS232 cable to the port on the LPS labeled RS232. Route the cable up through
the opening in the projector's baseplate into the LVPS compartment. Connect the other end of the
RS232 cable to the port labeled RS232 in the LVPS compartment.
c. Connect one end of the Interlock cable to the port on the LPS labeled Interlocks. Route the cable up
through the opening in the projector's baseplate that you ran the RS232 cable. Connect the other end of
the Interlock cable to the port labeled Interlock in the LVPS compartment.
2-16
Downloaded From projector-manual.com Christie Manuals
When connecting the LPS and the Igniter the black (-) power cable must be
You must connect the LPS to the projector before you connect it to AC power.
1) Certified electrician required. 2) Ground (earth) connection is necessary for
Use an appropriate strain relief connector on the AC supply cable to prevent
400V
LPS Breaker
Phase Status LEDs
3
Configure the LPS for incoming AC
NOTE: Internal Input Line Voltage
must match AC available at the site.
Power Connector
Terminal Block
AC Input
Terminal Block
Earth Ground
Connect to 3-phase AC supply:
4.
• 208 VAC in N. America
• 200 VAC in Japan
• 380-415 VAC in Europe
Line cord not supplied. Must supply
appropriate strain relief.
switch setting
Interlocks
Connect communication
1
cables to projector
(inside LVPS compartment)
RS232
+ DC
Connect lamp leads
2
– DC
to projector (to igniter)
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)