Christie CP4230 User Manual page 20

Section 2: Installation and Setup
NOTE: Keep the projector lens as parallel to the screen as possible, even if significantly above the screen
center. When a particularly short throw distance combines with a very wide screen, you may have to forfeit
some aim and stay more parallel to the screen. In such cases, some lens offset can reduce the keystone dis-
tortion.
2. Locate the lamp power supply so that its cables reach the left side of the projector.
3. If you are using an optional rack stand assemble the rack stand using the instructions provided with the
rack stand. NOTES: 1) For better access, wire the LPS before installing it into the rack stand. 2) Use the
hold down clamp (P/N 116-100101-01) when securing the projector to the rack stand.
4. Install and secure the lamp power supply (LPS) in the rack stand:
a. Remove the right (the operator's side) panel of the rack stand.
b. Remove the cross bar.
Snap 3 piece airflow duct
together using stand out pins
3.
2-6
Downloaded From projector-manual.com Christie Manuals
2.
Lift LPS into frame
1.
Insert support frame
020-100621-02 Rev. 1 (01-2012)
CP4230 User Manual