Installation Safety And Warning Guidelines; Position The Projector And Lamp Power Supply - Christie CP4230 User Manual

2.4

Installation Safety and Warning Guidelines

WARNING
installed in a restricted access location.
WARNING
WARNING
dled. Always wear manufacturer approved protective safety clothing (gloves, jacket, face
shield) whenever the lamp door is open or when handling the lamp. Only qualified technicians
should install projector lamps.
WARNING
safety strap on the rear of the projector.
WARNING
short distance. Remove the lamp before transporting the projector.
tor to the right. This can introduce an air bubble into the coolant hoses that can result in an air
lock and the overheating of the projector.
new lamp in the projector.
2.5

Position the Projector and Lamp Power Supply

1. Position the projector at an appropriate throw distance (projector-to-screen distance) and vertical position.
Ideally, center the projector with the theatre screen. If space is limited, aim the projector slightly off-center.
This increases side keystoning, but reduces the horizontal lens offset required.
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)
Downloaded From projector-manual.com Christie Manuals
QUALIFIED TECHNICIAN REQUIRED for all installations. This product must be
Never operate the projector without all of its covers in place.
The projector uses a high-pressure lamp that may explode if improperly han-
To prevent the projector from tipping unexpectedly, you must install the
our or more people are required to safely lift and carry one projection head a
Keep the projector level when you lift or transport it. Avoid tilting the projec-
Perform a automatic LampLOC™ adjustment when you move, level, or install a
Figure 2-1 Position the Projector
Section 2: Installation and Setup
2-5