Christie CP4230 User Manual page 130

Section 7: Maintenance
9. Re-install the front lamp duct. As you install the front lamp
duct, lift the small light shield on the rear lamp duct cover so
that it does not get jammed between the two pieces when they
come together. (Figure 7-3) To ensure a good fit between the
two pieces, squeeze the top and bottom cover snaps to ensure
they are locked in place. The light shield should move freely to
the touch.
10. Close the internal lamp door and manually turn the 2
thumbscrews to lock it in place.
11. Turn the circuit breaker for the projector on.
12. On the Touch Panel Controller (TPC), tap and hold the green
power
13. Record the new lamp information:
a. Tap Menu > Advanced Setup > Lamp History.
b. Tap Add Lamp.
c. Complete the fields in the Add Lamp dialog.
d. Tap Save.
14. On the TPC, tap and hold the light bulb
15. Run a LampLOC™ on the new lamp:
a. Tap Menu > Advanced Setup > LampLOC™ Setup.
b. Tap Do Auto.
7-6
Downloaded From projector-manual.com Christie Manuals
Figure 7-2 Installing the Lamp
icon.
Figure 7-3 Light Shield on Front
icon to ignite the lamp.
Lamp Duct
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)