Christie CP4230 User Manual page 32

Section 2: Installation and Setup
5. Connect one end of the LPS power cord into the socket on the LPS labeled CP4230/4230 Projector ONLY.
Connect the other end of the power cord into the socket on the front of the projector.
WARNING WARNING
WARNING!
must terminate the power connector terminal block correctly to ensure 200VAC-240VAC output. These
connectors are controlled with the power connector breaker. For more information, see the Interconnect
Drawing provided with your projector.
6. Turn the LPS Breaker ON.
7. If you are using the extraction unit and CP4230 projector power connectors, turn them on.
8. Connect the AC from the site to the socket located on the front bezel of the projector.
2-18
Downloaded From projector-manual.com Christie Manuals
DO NOT power the projector directly from a building electrical source.
If you use the power connectors to power the CP4230 projector or the extraction unit, you
to extractor
(optional)
CP4230 Projector &
Extraction Unit Power
Connectors
Connect to AC at site
NOTE: Shroud removed for clarity
Communication
cables
Connect to AC at site
Communication
cables
Lamp leads
to projector
Connect to AC at site with owner supplied line cord
200-240VAC (as indicated on licence label)
Lamp leads
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)