Source File Setup Window - Christie CP4230 User Manual

Control
In
Out
6.14.6

Source File Setup Window

Use the Source File Setup window to create source files that store resolution, offset, and aspect ratio settings
for input devices
Table 6.18 Advanced Setup: Source File Setup Window
Control
1: Resolution
2: Offset
3: Aspect Ratio
CP4230 User Manual
020-100621-02 Rev. 1 (1-2012)
Downloaded From projector-manual.com Christie Manuals
Description
Moves the MALM to the right or left. If the MALM is in the OUT position (right), the MALM
moves to the IN position (left) before the incremental adjustments begin.
Moves the MALM to the right or left. If the MALM is in the IN position, the MALM moves to the
OUT position (right) before the incremental adjustments begin.
. Tap Menu > Advanced Setup > Source File Setup.
1
Figure 6-23 Source File Setup Window
Description
The X and Y resolution of the incoming signal. For example, 2048 (X) and 858 (Y) or 1920 (X) and
1080 (Y). The resolution must match the incoming signal format. Tap once to increase or decrease
the resolution by a single increment. Tap and hold a button to increase or decrease the resolution by
multiple increments.
The amount of incoming data to discard. Set the values to zero to process all incoming data. Tap
once to increase or decrease the offset by a single increment. Press and hold a button to increase or
decrease the offset by multiple increments. The allowable X range is -4096 to 4096 pixels and Y
range of -2160 to 2160 pixels.
The aspect ratio for the incoming signal. The allowable range is 0 to 7.99.
2
3
Section 6: Projector Menus
6-31