Connect Devices To The 3D Connector - Christie CP4230 User Manual

3.4

Connect Devices to the 3D Connector

The 3D connector is a 15-pin D-sub connector (female) located on the PIB input panel. This table lists the
control functions available through the 3D connector.
PIN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
CP4230 User Manual
020-100621-02 Rev. 1 (1-2012)
Downloaded From projector-manual.com Christie Manuals
SIGNAL NAME
+12V
GND
GND
RS232_RX
RS232_TX
CONN_3D_MODE+
CONN_SYNC+
3D_INPUT_REFRERENCE+
+12V
3D_INPUT_REFRERENCE-
3D_DISPLAY_REFERENCE+
3D_DISPLAY_REFERENCE-
CONN_3D_MODE-
CONN_SYNC-
Not connected
Section 3: Connecting Devices to the Projector
DIRECTION DESCRIPTION
Out Power to 3D device. Maximum 1A (total between both +12V
pins).
/ Ground
/ Ground
In Data to projector from 3D device. 1200 Baud, 8 bits, no parity.
Currently unsupported.
Out Data to projector from 3D device. 1200 Baud, 8 bits, no parity.
Currently unsupported.
Out SYNC from projector. To projector GPO collector. Compatible
with current projector GPIO requirements and restrictions.
(24VDC max, 50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
Out SYNC from projector. To projector GPO collector. Compatible
with current projector GPIO requirements and restrictions.
(24VDC max, 50mA max)
In 3D L/R Input Reference (P)
(Voltage Limit: 1.4VDC to 12VDC)
Out Power to 3D system. Maximum 1A (Total between both +12V
pins)
In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
Out 3D mode state from projector. From projector GPO emitter.
Compatible with current projector GPIO requirements and
restrictions. (24VDC max, 50mA max)
Out SYNC from projector. From projector GPO emitter. Compati-
ble with current projector GPIO requirements and restrictions.
(24DC max, 50mA max)
3-7