Install The Touch Panel Controller (Tpc); Connect External Exhaust Ducting - Christie CP4230 User Manual

2.8

Install the Touch Panel Controller (TPC)

1. Loosen the mounting arm so that the end fits over the ball joint located on the rear panel of the projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the projector.
4. Adjust the angle of the TPC.
2.9

Connect External Exhaust Ducting

Connect the existing outside-venting ductwork to the 8 inch
diameter exhaust port on the top of the projector. Confirm
that there are no obstructions or bends in the ducting, all air
intakes are free of obstructions, and the vane switch at the
exit duct moves freely.
The pre-installed outside-venting duct should be rigid at the
projector and must also include a heat extractor and blower
that maintains a minimum of 450 CFM* when the projector is
operating at less than or equal to 25°C ambient and less than
3,000 feet, when measured at the projector exhaust opening.
WARNING
• *600 CFM is required in projection rooms with an
ambient temperature above 25°C or located at an
elevation greater than 3000 feet above sea level.
• At minimum, a 10" long, strong metal duct must be installed at the projector to prevent
glass shards from exiting the duct in the event of a lamp explosion.
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)
Downloaded From projector-manual.com Christie Manuals
Section 2: Installation and Setup
2-9