Hardware Setup; Install A 3D Server With An Ycxcz Interface - Christie CP4230 User Manual

Section 4: Adjust the Image
4.14.2

Hardware Setup

Use an infrared emitter to control gating in active glasses, a polarizing Z-screen (Pi-cell) with passive glasses
or filter wheel with passive glasses.
Table 4.1 3D Hardware Systems
Installed/
Mounted
Components
Silver Screen
3D Glasses

4.14.3 Install a 3D Server with an YCxCz Interface

1. Install and connect your 3D hardware to the projector.
2. Edit and apply the default 3D lamp file:
a. Tap Menu > Advanced Setup > Lamp Power/LiteLOC Setup.
b. Set the brightness percentage for the lamp in the Power % field
c. Tap Save.
d. Repeat steps b and c for all remaining 3D channels.
3. Measure the color gamut and create a measured color file.
4. Edit the channel values for your theatre. The predefined 3D Channels are named: 3D Flat 1998x1080 and
3D Scope 2048x858.
5. Run test patterns to verify the performance of the new 3D channel formats.
4-8
Downloaded From projector-manual.com Christie Manuals
RealD RealD XL
Z-screen Box
Z-screen XL box
mounted in mounted in
front of the front of the
projection projection
lens lens
Yes Yes
Polarizing Polarizing
circular circular
glasses glasses
Dolby Xpand
Filter
Wheel
Installed filter None
wheel inside
the projector
No No
Color filter Active glasses
glasses
.
Master Dual
Image Projector
Installed Polarizing
wheel in front plates in front
of the of lenses
projector
Yes Yes
Circular Polarizing
polarized circular or
glasses linear glasses
CP4230 User Manual
020-100621-02 Rev. 1 (1-2012)