c. Insert the LPS support into the rack stand and align the pins with the holes.
d. Lift the LPS into the frame.
e. Remove the bottom 10 panels from the back of the rack stand.
f. Assemble the three piece airflow duct (supplied with LPS). First snap the 2 "L" shaped parts together,
g. Position the airflow duct directly behind the LPS.
h. Insert the airflow duct into the rack stand from the
i. Secure the airflow duct to the rack stand using the
j. Wire all of the components in the rack stand and
k. Twist LPS cable 12 twist/meter.
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)
Downloaded From projector-manual.com Christie Manuals
and then snap this into the 6 stand out pins of the third piece (flat panel).
Do not install any components in
CAUTION!
front of the lamp power supply that will restrict air-
flow.
outside.
screws from the rack stand panels.
replace the side panel.
Section 2: Installation and Setup
2-7