Feed Originals To The Adf (Optional) - Canon imagePRESS C7011VPS series Operation Manual

Feed originals to the ADF (optional)

Introduction
You can use the ADF to feed a stack of originals at once, face up. Feeding originals in the portrait
position is referred to as long-edge feed (LEF/vertical). Feeding originals in the landscape position
is referred to as short-edge feed (SEF/horizontal).
NOTE
• If the top edge of the original is not aligned with the back edge of the slide guide, your original
may not be scanned correctly, depending on the copy mode that you have set.
• Originals of the A4, B5 and LTR sizes can be placed either vertically or horizontally. However,
the scanning speed for horizontally placed originals is somewhat slower than vertically placed
originals.
• Horizontally placed A4 and B5 originals are referred to as A4R and B5R.
• Horizontally placed LTR originals are referred to as LTRR
• A3, B4, 11" x 17" and LGL originals must be placed horizontally. A5 and STMT must be placed
vertically.
You can place the following originals into the ADF:
• Weight
- One-sided scanning: 50 to 216 g/m² / 13 to 57 lb bond
- Two-sided scanning: 50 to 216 g/m² / 13 to 57 lb bond
(A3, B4, A4R, B5R: 50 to 200 g/m² / 13 lb bond to 54 lb bond)
(11" x 17", LGL, LTRR: 50 to 200 g/m² / 13 to 53 lb bond)
• A3, B4, A4, A4R, B5, B5R, or A5
(A5 originals cannot be placed horizontally. (A5R))
• 11"x 17", LGL, LTR, LTRR, STMT
(STMT originals cannot be placed horizontally. (STMTR))
• Tray Capacity: up to 100 sheets (80 g/m² / 22 lb bond)
IMPORTANT
• Thin originals may become creased, if used in a high temperature or high humidity
environment.
• Do not place the following types of originals into the feeder:
- Originals with tears or large binding holes
- Severely curled originals or originals with sharp folds
- Clipped or stapled originals
- Carbon backed paper or other originals which may not feed smoothly
- Transparencies and other highly transparent originals
• If the same original is fed through the feeder repeatedly, the original may fold or become
creased, and make feeding impossible. Limit repeated feeding to a maximum of 30 times (this
number varies, depending on the type and quality of the original).
• If the feeder rollers are dirty from scanning originals written in pencil, perform the feeder
cleaning procedure.
Clean the automatic document feeder rollers on page 346
• Always smooth out any folds in your originals before placing them into the feeder.
Procedure
1.
Adjust the slide guides to fit the size of your originals.
Feed originals to the ADF (optional)
Chapter 9 - Carry out copy jobs 239