Change The Warning Time - Canon imagePRESS C7011VPS series Operation Manual

Change the warning time

Change the warning time
Introduction
When operator interaction is required now or soon, the dashboard and the operator attention
light can warn you. This is a trigger that action is required now or soon, for example load a
required media type or empty an output location. You can define how long in advance the
warning message is displayed.
By factory default, the function [Warning in advance] is enabled and set to 10 minutes. Then the
dashboard starts to display the warning 10 minutes before an action becomes inevitable. If you
do not respond to the warning message, the printer will stop. Depending on the urgency of the
warning message, the vertical bar in the dashboard and the operator attention light are orange or
red.
NOTE
• The operator attention light is linked to the status of the machine. For example, when the
dashboard displays an orange warning, the orange light of the operator attention light also
lights up.
• You can only change the warning time when the [Warning in advance] function is enabled.
Procedure
1. Touch [System] -> [Setup] -> [Warning time].
2. Touch the - or + button to decrease or increase the warning time in steps of 1 minute. You can set
a time from 1 - 60 minutes.
3.
Press [OK].
84 Chapter 6 - Adapt printer settings to your needs