Canon imagePRESS C7011VPS series Operation Manual page 112

Load the media into the paper tray
IMPORTANT
• Do not load paper into the paper tray that has been previously printed onto, as this may result
in a malfunction or damage to the copier. Always use the special feeder to feed paper when
you want to print onto the back of a sheet of paper that already has something printed on its
front side (2nd side of 2-Sided print).
• Paper which has been rolled or curled must be straightened out prior to use.
• Make sure that the height of the paper stack does not exceed the loading limit mark
back of the paper tray.
NOTE
• Each paper tray holds approximately 1,000 sheets of paper (80 g/m² / 22 lb bond).
• If there are instructions on the package of paper about which side of the paper to load, follow
those instructions.
• When the paper is loaded into the paper tray, the side facing down is the one printed on.
• If problems occur, such as poor print quality or paper jams, try turning the paper stack over,
and reload it. However, you cannot turn the texture paper and 1-Sided Coated paper over.
Change the new paper.
6. Lower the paper holder plate.
7.
Gently push the paper tray back into the machine until it clicks into place in the closed position.
The inside lifter automatically rises, and prepares the paper tray for printing.
CAUTION
When closing the paper tray, be careful not to get your fingers caught, as this may result in
personal injury.
IMPORTANT
You will not be able to make copies or print if you load paper that exceeds the loading limit, or if
the paper tray is not completely pushed into the machine. Always check that the paper trays are
in place, and that the paper does not exceed the loading limit.
112 Chapter 7 - Media handling
at the