Edit a transaction setup
Edit a transaction setup
Procedure
1.
Go to [Transaction printing] -> [Setups].
2.
Check the box next to the setup you want to change.
3.
If required, click the [Edit] button to change the name or description of the setup, then click [OK].
4.
Click [Open] to allow changes to the setup.
5.
Depending on the type of setup you want to change, click [IPDS setup] or [PCL setup].
NOTE
PCL is not available for all products. If you only have 1 license, the other PDL is not available.
You can change the settings:
• By group (click the pencil at the right-hand side of the group settings).
• By item (click the pencil behind the individual settings).
After you change the settings of a transaction setup, you must load the transaction setup to make
the setup changes active.
216
Chapter 8 - Carry out print jobs