Canon imagePRESS C7011VPS series Operation Manual page 116

Adjust the paper tray to hold a different media size
6.
Load all remaining paper whose size you want to change into the paper tray.
CAUTION
When loading paper into the paper tray, take care not to cut your hands on the edges of the
paper.
IMPORTANT
• Do not load paper into the paper tray that has been previously printed onto, as this may result
in a malfunction or damage to the copier. Always use the special feeder to feed paper when
you want to print onto the back of a sheet of paper that already has something printed on its
front side (2nd side of 2-Sided print).
• Paper which has been rolled or curled must be straightened out before loading it into the
paper tray.
• Make sure that the height of the paper stack does not exceed the loading limit mark
inside of the paper tray.
• Never place paper or any other items in the empty part of the paper tray next to the paper
stack. Doing so may cause paper jams.
NOTE
• If there are instructions on the package of paper about which side of the paper to load, follow
those instructions.
• When paper is loaded into the paper tray, the side facing down is the one printed on.
• If problems occur, such as poor print quality or paper jams, try turning the paper stack over,
and reload it. However, you cannot turn the texture paper and 1-Sided Coated paper over.
Change the new paper.
• When loading paper, make sure that the height of the paper stack does not exceed 20 mm /
13/16". If the height of the paper stack exceeds 20 mm / 13/16", the edges of the paper stack
may become curled or creased, and poor print quality may result.
7.
Lower the paper holder plate.
8.
Change the paper tray's size plate to match the new paper size.
116 Chapter 7 - Media handling
on the