Change The Finishing Method - Canon imagePRESS C7011VPS series Operation Manual

Change the finishing method

Change the finishing method
Introduction
The required finishing method is usually set in the printer driver. However, you can change the
finishing method on the operator panel.
Depending on the configuration of your system you can change the following finishing methods,
for example.
• Number of staples.
• Number of punch holes.
• The location of the staples or punch holes.
Procedure
1.
Touch [Jobs] -> [Waiting jobs], or select a [DocBox].
2.
Touch the job you want to change.
NOTE
You can only change the settings of the active print job
[Stop] button
3. Touch [Properties], or touch the job twice to open the [Properties] window.
4. Touch the [Binding] button.
5.
Make the required changes.
6.
Press [OK].
7.
Press [OK].
198 Chapter 8 - Carry out print jobs
two times).
after you stopped the printer (press the