Replacing The Waste Toner Container - Canon imagePRESS C7011VPS series Operation Manual

Replacing the waste toner container

Replacing the waste toner container
Introduction
This section describes how to replace the waste toner container when this container becomes
full. You can print for a while even if you do not replace the waste toner container immediately.
(The number of sheets may differ depending on the contents to print.) If you continue to print, an
error occurs and you cannot continue printing.
WARNING
Do not burn or throw used waste toner containers into open flames. Also, do not store waste
toner containers in places exposed to open flames, as this may cause the toner to ignite,
resulting in burns or a fire.
IMPORTANT
• Contact your supplier for information about the local regulations for disposal of waste toner.
Use the provided cap to cover up the opening of the used waste toner container.
• Used toner cannot be reused. Do not mix new and used toner together.
• Use only waste toner containers intended for use with this machine.
• Do not replace waste toner container until the message prompting you to do so appears.
NOTE
• Complete instructions on how to replace the waste toner container.
• If the waste toner container must be replaced during a print job, the remaining prints are
made after the new waste toner container is installed.
• The waste toner containers can be replaced even if the machine is in operation.
Procedure
1.
Pull out the waste toner container tray.
2. Attach the cap of waste toner container.
3.
Remove the waste toner container.
330 Chapter 13 - Add toner and staples