Finishing Component Replacement; Replacing The System Cover - Sun Microsystems Sun Ultra 5 Service Manual

10
C H A P T E R

Finishing Component Replacement

This chapter describes the activities you must do after you finish removing and
replacing internal system components. This chapter also explains how to externally
control standby operation.
This chapter contains the following topics:
Section 10.1 "Replacing the System Cover" on page 10-1
Section 10.2 "Powering On the System" on page 10-2
10.1

Replacing the System Cover

1. Remove the wrist strap from the system chassis and from your wrist.
2. Replace the Ultra 5 system cover as follows (
a. Position the system cover onto the system chassis. Slide the system cover
toward the front of the system until the cover tabs lock.
b. Using a No. 2 Phillips-head screwdriver, replace the two screws securing the
system cover to the chassis.
):
FIGURE 10-1
10-1