Adjust The Service Brakes; Mechanical Disc Brakes - Taylor-Dunn SC-100-24 Service And Replacement Parts Manual

Table of Contents

Advertisement

Brakes

ADJUST THE SERVICE BRAKES

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.

Mechanical Disc Brakes

1: Remove the floorboard.
2: Release the park brake.
3: Depress the treadle by hand so that all play is
removed from the slip connector and clamp the
throttle rod in position. The throttle arm should
still be against the throttle stop.
4: Loosen both brake rod jam nuts and adjust the
brake rod so that there is no play in the brake
linkages. Move the equalizer back and forth while
adjusting to ensure all play is removed. Adjust by
hand, do not use a wrench.
5: Tighten the brake rod an additional ½ turn and
remove the clamp from the throttle rod.
Note: If you have reached the end of the threads
on the brake rod, then move the left and right
brake linkages to the secondary adjustment
holes. There are two sets of holes on each
linkage.
6: Push the vehicle back and forth a few feet. When
the treadle is gently released, the throttle arm
should be contacting the throttle stop and there
should be no more than 1/16" clearance at the
slip connector. The back of the treadle should
about level with the floorboard.
a.
If not within specification then
loosen or tighten the brake rod 1/8
turn at a time until within specification.
7: Tighten both brake rod jam nuts.
8: Adjust the parking brake.
9: Install the floorboard.
10: Reconnect the main positive and negative cables
at the batteries.
11: Remove blocks from behind the wheels.
12: Release the park brake and test drive the vehicle.
Page 60
WARNING
• Make sure the key-switch is in the "OFF" position,
then remove the key.
• Place the forward-reverse switch in the center
"OFF" position.
• Set the park brake.
• Place blocks under the rear wheels to prevent
vehicle movement.
• Disconnect the main positive and negative cables
at the batteries.
SC-100
MA-100-03

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-100-36Sc-100-48

Table of Contents