Lan Or Wan Port Leds Not On; Troubleshoot The Web Management Interface - NETGEAR FVS318G Reference Manual

LAN or WAN Port LEDs Not On

If either the LAN LEDs or WAN LEDs do not light when the Ethernet connection is made,
check the following:
• Make sure that the Ethernet cable connections are secure at the VPN firewall and at the
hub, router, or workstation.
• Make sure that power is turned on to the connected hub, router, or workstation.
• Be sure that you are using the correct cables.
When connecting the VPN firewall's WAN ports to one or two devices that provide the
Internet connections, use the cables that are supplied with the devices. These cables
could be standard straight-through Ethernet cables or Ethernet crossover cables.

Troubleshoot the Web Management Interface

If you cannot access the VPN firewall's web management interface from a computer on your
local network, check the following:
• Check the Ethernet connection between the computer and the VPN firewall.
For more information, see
• If your computer's IP address is shown as 169.254.x.x: Windows and Mac operating
systems generate and assign an IP address if the computer cannot reach a DHCP server.
These autogenerated addresses are in the range of 169.254.x.x. If your IP address is in
this range, check the connection from the computer to the VPN firewall and reboot your
computer.
• If your VPN firewall's IP address was changed and you do not know the current IP
address, reset the VPN firewall's configuration to factory default settings.
This sets the VPN firewall's IP address to 192.168.1.1. For more information, see
the Default Configuration and Password
Tip: If you do not want to revert to the factory default settings and lose your
configuration settings, you can reboot the VPN firewall and use a
sniffer to capture packets sent during the reboot. Look at the ARP
packets to locate the VPN firewall's LAN interface address.
• Make sure that Java, JavaScript, or ActiveX is enabled in your browser.
If you are using Internet Explorer, click the Refresh button to be sure that the Java applet
is loaded.
• Try quitting the browser and launching it again.
• Clear the browser's cache.
• Make sure that you are using the correct login information.
NETGEAR ProSAFE VPN Firewall FVS318G v2
LAN or WAN Port LEDs Not On
on page 397.
Troubleshooting
388
on page 388.
Restore