NETGEAR FVS318G Reference Manual page 148

The DMZ WAN Rules screen displays. The IPv4 radio button is selected by default. The
screen displays the IPv4 settings.
3. Click the Add table button under the Outbound Services table.
4. Enter the settings as described in
In addition to selections from the Service, Action, and Log lists, you must make
selections from the following lists:
• DMZ Users
• WAN Users
Unless your selection from the Action list is BLOCK always, you also must make
selections from the following lists:
• Select Schedule
• QoS Priority
• NAT IP (This list is available only when the WAN mode is NAT. If you select Single
Address, the IP address specified must fall under the WAN subnet.)
5. Click the Apply button.
Your changes are saved.
NETGEAR ProSAFE VPN Firewall FVS318G v2
Table 29
on page 128.
Firewall Protection
148