NETGEAR FVS318G Reference Manual page 219

Table 42. IPSec VPN Wizard settings for an IPv6 gateway-to-gateway tunnel (continued)
Setting
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
IPv6 Prefix Length
a. Both local and remote endpoints must be defined as either FQDNs or IP addresses. A combination of an IP address and
an FQDN is not supported.
6. Click the Apply button.
Your changes are saved.
7. Configure a VPN policy on the remote gateway that allows connection to the VPN firewall.
8. Activate the IPSec VPN connection:
a. Select VPN > Connection Status.
b. Locate the policy in the table, and click the Connect table button.
The IPSec VPN connection becomes active.
Virtual Private Networking Using IPSec and L2TP Connections
NETGEAR ProSAFE VPN Firewall FVS318G v2
Description
Enter the LAN IPv6 address of the remote gateway.
Note: The remote LAN IPv6 address must be different from the local LAN
IPv6 address. For example, if the local LAN IPv6 address is FEC0::1, the
remote LAN IPv6 address could be FEC0:1::1 but could not be FEC0::1. If
this information is incorrect, the tunnel fails to connect.
Enter the prefix length for the remote gateway.
219