NETGEAR FVS318G Reference Manual page 34

Table 4. Internet IP address settings
Setting Description
Get Dynamically If your ISP did not assign you a static IP address, select the Get Dynamically from ISP
from ISP radio button. The ISP automatically assigns an IP address to the VPN firewall using
DHCP network protocol.
Client Identifier
Vendor Class Identifier
Use Static IP If your ISP assigned you a fixed (static or permanent) IP address, select the Use Static
Address IP Address radio button, and enter the following settings:
IP Address
IP Subnet Mask
Gateway IP Address
9. In the Domain Name Server (DNS) Servers section, specify the DNS settings as described
in the following table.
See the following figure.
Table 5. DNS server settings
Setting
Get Automatically
from ISP
NETGEAR ProSAFE VPN Firewall FVS318G v2
If your ISP requires the client identifier information to assign an
IP address using DHCP, select the Client Identifier check box.
If your ISP requires the vendor class identifier information to
assign an IP address using DHCP, select the Vendor Class
Identifier check box.
The static IP address assigned to you. This address identifies
the VPN firewall to your ISP.
The subnet mask is usually provided by your ISP.
The IP address of the ISP's gateway is usually provided by
your ISP.
Description
If your ISP did not assign any Domain Name Server (DNS) addresses, select the Get
Automatically from ISP radio button.
IPv4 and IPv6 Internet and Broadband Settings
34