NETGEAR FVS318G Reference Manual page 172

Table 31. Attack Checks screen settings for IPv4 (continued)
Setting
Jumbo Frames
Enable Jumbo
Frame
4. Click the Apply button.
Your changes are saved.
IPv6 Attack Checks
To enable IPv6 attack checks for your network environment:

1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the Username field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click the Login button.
The Router Status screen displays. After five minutes of inactivity, which is the default
login time-out, you are automatically logged out.
2. Select Security > Firewall > Attack Checks.
The Attack Checks screen displays.
3. In the upper right of the screen, select the IPv6 radio button.
4. Configure the following settings:
NETGEAR ProSAFE VPN Firewall FVS318G v2
Description
Jumbo frames allow multiple smaller packets to be combined into a single larger
packet, reducing network overhead and increasing data transfer performance.
Jumbo frames are supported on ports 1, 2, 3, and 4 only.
Select the Jumbo Frame check box to enable jumbo frames. By default, jumbo
frames are disabled.
Note: Jumbo frames are not supported on Fast Ethernet interfaces.
Firewall Protection
172