NETGEAR FVS318G Reference Manual page 64

NETGEAR ProSAFE VPN Firewall FVS318G v2
Table 11. Add VLAN Profile screen settings (continued)
Setting Description
Port Membership
Port 1, Port 2, Port 3, Select one, several, or all port check boxes to make the ports members of this
Port 4, Port 5, Port 6, VLAN.
Port 7, and 
Note:
Port 8 / DMZ
data frames that are tagged with the VLAN ID.
IP Setup
IP Address Enter the IP address of the VPN firewall (the factory default address is
192.168.1.1).
Note:
different subnets.
Note:
through the browser to the VLAN, you are disconnected. You then must open a
new connection to the new IP address and log in again. For example, if you change
the default IP address 192.168.1.1 to 10.0.0.1, you now must enter
https://10.0.0.1 in your browser to reconnect to the web management interface.
Subnet Mask Enter the IP subnet mask. The subnet mask specifies the network number portion
of an IP address. Based on the IP address that you assign, the VPN firewall
automatically calculates the subnet mask. Unless you are implementing
subnetting, use 255.255.255.0 as the subnet mask (computed by the VPN
firewall).
DHCP
Disable DHCP Server If another device on your network is the DHCP server for the VLAN, or if you
intend to manually configure the network settings of all of your computers, select
the Disable DHCP Server radio button to disable the DHCP server. Except for
the default VLAN for which the DHCP server is enabled, this is the default setting.
A port that is defined as a member of a VLAN profile can send and receive
Ensure that the LAN port IP address and DMZ port IP address are in
If you change the LAN IP address of the VLAN while being connected
LAN Configuration
64