NETGEAR FVS318G Reference Manual page 118

3. In the upper right of the screen, select the IPv6 radio button.
4. Click the Add table button.
5. Enter the settings as described in the following table.
Table 26. Add IPv6 Static Routing screen settings
Setting
Route Name
Active
IPv6 Destination
IPv6 Prefix Length
Interface
IPv6 Gateway
Metric
6. Click the Apply button.
Your changes are saved.
NETGEAR ProSAFE VPN Firewall FVS318G v2
Description
The route name for the static route (for purposes of identification and
management).
To make the static route effective, select the Active check box.
Note: A route can be added to the table and made inactive if not needed. This
allows you to use routes as needed without deleting and re-adding the entries.
The destination IPv6 address of the host or network to which the route leads.
The destination IPv6 prefix length of the host or network to which the route leads.
Select the physical or virtual network interface (WAN1, sit0 Tunnel, LAN, or DMZ
interface) through which the route is accessible.
The gateway IPv6 address through which the destination host or network can be
reached.
The priority of the route. Select a value between 2 and 15. If multiple routes to the
same destination exist, the route with the lowest metric is used.
LAN Configuration
118