NETGEAR FVS318G Reference Manual page 273

4. Specify the settings that are described in the following table.
Table 60. VPN client IPSec configuration settings (Mode Config)
Setting
VPN Client
address
Address Type
Remote host
address
Subnet mask
ESP
PFS and Group
5. To use the new settings immediately, click the Apply button.
6. To keep the settings for future use, click the Save button.
Configure the Mode Config Global Parameters
To specify the global parameters:

1. Right-click the VPN client icon in your Windows system tray, and select Configuration
Panel.
The Configuration Panel screen displays.
Virtual Private Networking Using IPSec and L2TP Connections
NETGEAR ProSAFE VPN Firewall FVS318G v2
Description
This field is masked out because Mode Config is selected. After an IPSec connection is
established, the IP address that is issued by the VPN firewall displays in this field.
Select Subnet address from the list.
The address that you must enter depends on whether you specified a LAN IP network
address in the Local IP Address field on the Add Mode Config Record screen of the
VPN firewall:
• If you left the Local IP Address field blank, enter the VPN firewall's default LAN IP
address as the remote host address that opens the VPN tunnel. For example, enter
192.168.1.1.
• If you specified a LAN IP network address in the Local IP Address field, enter the
address that you specified as the remote host address that opens the VPN tunnel.
Enter 255.255.255.0 as the remote subnet mask of the VPN firewall that opens the VPN
tunnel. This is the LAN IP subnet mask that you specified in the Local Subnet Mask field
on the Add Mode Config Record screen of the VPN firewall. If you left the Local Subnet
Mask field blank, enter the VPN firewall's default IP subnet mask.
Encryption From the list, select 3DES as the encryption algorithm.
Authentication From the list, select SHA-1 as the authentication algorithm.
Mode From the list, select Tunnel as the encapsulation mode.
Select the PFS check box, and select the DH2 (1024) key group from the list.
Note: On the VPN firewall, this key group is referred to as Diffie-Hellman Group 2 (1024
bit).
273