View The Attached Devices And The Dhcp Log - NETGEAR FVS318G Reference Manual

3. In the upper right of the screen, click the Status option arrow.
The type of connection determines the information that is displayed on the Connection
Status screen. The screen can display the information that is described in the following
table:
Table 85. Connection Status screen information for an IPv6 connection
Item
Connection Time
IPv6 Connection Type
IPv6 Connection Status
IP Address
Gateway
Primary DNS Server (IPv6)
Secondary DNS Server (IPv6)
To establish the connection, click the Connect button.
To disconnect the connection, click the Disconnect button.

View the Attached Devices and the DHCP Log

The LAN Groups screen shows the network database, which is the Known PCs and Devices
table, which contains all IP devices that VPN firewall discovered on the local network. The
LAN Setup screen lets you access the DHCP log.
View the Attached Devices
The Known PCs and Devices table contains a list of all known computers and network
devices that are assigned dynamic IP addresses by the VPN firewall, were discovered by
other means, or were manually added. Collectively, these entries make up the network
NETGEAR ProSAFE VPN Firewall FVS318G v2
Description
The period that the VPN firewall is connected through the WAN port.
The connection type can be either Dynamic IP (DHCP), Static, or PPPoE.
The connection status can be either Connected or Disconnected.
The IPv6 addresses that were automatically detected or that you
configured on the Broadband ISP Settings (IPv6) screen.
Note: The Gateway and DNS Server (IPv6) fields apply only to static IPv6
and PPPoE IPv6 connections.
Note: For more information, see
IPv6 Internet Connection
Connection
on page 42.
Monitor System Access and Performance
376
Use a DHCPv6 Server to Configure an
Configure a Static IPv6 Internet
on page 40 and