View The Attached Devices And The Dhcp Log - NETGEAR ProSafe FVS318N Reference Manual

View the Attached Devices and the DHCP Log

The LAN Groups screen shows the network database, which is the Known PCs and Devices
table, which contains all IP devices that wireless VPN firewall has discovered on the local
network. The LAN Setup screen lets you access the DHCP log.
View the Attached Devices

To view the attached devices on the LAN Groups screen:
Select Network Configuration > LAN Setup > LAN Groups. The LAN Groups screen
displays. (The following figure shows some examples in the Known PCs and Devices table.)
Figure 222.
The Known PCs and Devices table contains a list of all known computers and network
devices that are assigned dynamic IP addresses by the wireless VPN firewall, have been
discovered by other means, or were manually added. Collectively, these entries make up the
network database. For information about how to edit the Known PCs and Devices table or
manually add entries to the table, see
For each attached computer or device, the Known PCs and Devices table displays the
following fields:
• Check box. Allows you to select the computer or device in the table.
• Name. The name of the computer or device. For computers that do not support the
NetBIOS protocol, the name is displayed as Unknown (you can edit the entry manually to
add a meaningful name). If the computer or device was assigned an IP address by the
DHCP server, then the name is appended by an asterisk.
• IP Address. The current IP address of the computer or device. For DHCP clients of the
wireless VPN firewall, this IP address does not change. If a computer or device is
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Manage the Network Database
Monitor System Access and Performance
370
on page 68.