Introduction - Freescale Semiconductor Motorola MMDS0508 Operation Manual

Installation

Introduction

NOTE:
20
Freescale Semiconductor, Inc.
Complete MMDS installation consists of configuring the platform board,
configuring and installing the appropriate emulation module (EM), and
making system cable connections. Consult the system components
section on page 9 for a list of all the system parts, including a separately
purchased EM. Note that EM configuration is specific to a particular EM;
follow the guidance of the specific EM user's manual. Follow the
guidance given in this section to complete the MMDS installation.
Figure 1 shows the right side of the MMDS station module, with the
access panel open. The recessed reset switch and power LED are on
the front of the station module. The logic cable A and B connectors (pod
A and pod B) are on the right (as you face the station module). When
using the logic clip cables, always attach the black clip to ground.
Figure 2 shows the left side of the station module, with the access panel
closed. The power cord socket, the power switch, and the 9-pin RS-232
serial connector are on the left as you face the station module. The
circular +5 V out connector, also on the left side of the station module,
is reserved for future features. A spacer covers the final enclosure
cutout, for a future conenctor.)
This manual uses the words left and right as you face the front of the
station module.
Follow the guidance of this chapter to complete the installation of your
MMDS.
Installation
For More Information On This Product,
Go to: www.freescale.com
MMDS0508OM/D
MOTOROLA