Table of Contents
Advertisement
Installing the EM
NOTE:
Removing the EM
MMDS0508OM/D
MOTOROLA
Freescale Semiconductor, Inc.
Perform these steps to install an EM in an MMDS enclosure:
•
Ensure that station module power is off.
•
Remove the panel from the station module top by first turning each
of the two 1/4-turn speed fasteners to the released position.
•
Install the EM on the platform board: Carefully fit the female 96-pin
connectors (located on the bottom of the EM) onto the
corresponding male DIN connectors on the top of the platform
board. Snap the EM onto the plastic standoffs and make sure that
the DIN connectors are joined together firmly.
•
Connect the target cable, if appropriate.
•
Reaffix the panel to the station module top.
Many EM boards may have 64-pin female DIN connectors. If so, these
will mate with the male DIN connectors on the platform board. The keyed
plastic on the connector will ensure proper alignment.
Complete these steps to remove an EM from an MMDS enclosure:
•
Ensure station module power is off.
•
Remove the panel from the station module top by first turning each
of the two 1/4-turn speed fasteners to the released position
•
Disconnect the target cable from the EM target connector.
•
Unsnap all nylon spacers from the edges of the EM. Then carefully
lift the EM straight up, separating it from the platform board.
•
Reaffix the panel to the station module top.
Installation
For More Information On This Product,
Go to: www.freescale.com
Installation
Installing the EM
25
Advertisement
Table of Contents
