Freescale Semiconductor Motorola MMDS0508 Operation Manual page 164

Command-Line Commands
RTVAR
164
Freescale Semiconductor, Inc.
Display Real-Time Variable
Examples:
>RTVAR 100 Display (in hexadecimal and binary) the byte
at
address 100
>RTVAR.B 110 Display (in hexadecimal and binary) the byte
at
address 110
>RTVAR.W 102 Display (in hexadecimal and decimal) the
word at
address 102
>RTVAR.S 200 5Display the 5-character ASCII string starting
at
address 200
(The RTVAR command also establishes variables for display in the
variables F8 window, but such variables are not real-time. The
32-variable maximum applies to variables established by both the
RTVAR and VAR commands.)
Real-time memory consists of memory enabled by the RTMEM
command, plus real-time variables created via the RTVAR command. All
this real-time memory must fit within a 1-Kbyte block. If an RTVAR
command would create a real-time variable that would not fit within the
1-Kbyte block (due to established real-time variables or memory enabled
by the RTMEM command), the system will not accept the RTVAR
command.
If any of the real-time memory overlays MCU I/O or EEPROM
addresses, it is available only for monitoring emulation MCU writes. (You
should not try to modify such locations.) You can monitor and modify
real-time memory locations that do not overlay MCU I/O or EEPROM
addresses.
Command-Line Commands
For More Information On This Product,
Go to: www.freescale.com
RTVAR
MMDS0508OM/D
MOTOROLA