Freescale Semiconductor Motorola MMDS0508 Operation Manual page 130

Command-Line Commands
GOTIL
NOTE:
130
Freescale Semiconductor, Inc.
Execute Program until Address
The GOTIL command executes the program in the emulator, beginning
at the address in the program counter (PC). Execution continues until
the program counter contains the specified address during an opcode
fetch cycle. If a map file has been loaded, symbols (or labels) from the
source code can be used as arguments.
Syntax:
GOTIL < address > | <symbol>
Where:
< address > Execution stop address. The < address > value
must be an instruction fetch address; if it is not,
code execution continues as if the command had
no < address > value.
<symbol> The label of an instruction in source code.
Be careful about using the G, GO, or GOTIL commands if the code
branches into internal RAM (for instance, option RAM) or EEPROM. An
execution stop address is invalid for internal locations.
Example:
>GOTIL 0FF0 Execute the program in the emulator up to
address 0FF0.
Command-Line Commands
For More Information On This Product,
Go to: www.freescale.com
GOTIL
MMDS0508OM/D
MOTOROLA