Freescale Semiconductor Motorola MMDS0508 Operation Manual page 46

User Screens
46
Freescale Semiconductor, Inc.
Table 5. Status Area Indicators
Indicator, Position
Bus analyzer state, left
screen edge, below
variables F8 window
Bus analyzer
sequence mode,
below variables F8
window
MCU state, left screen
edge above debug F10
window
RESETIN signal state,
below source/code F2
window
RESETOUT signal
state,
between variables F8
and memory F3
windows
Logging state, between
variables F8 and
memory F3 windows
Target system power,
between variables F8
and memory F3
windows
Communications port
and rate, above debug
F10 window
Special status
message, to the right
of the MCU state status
area, above debug F10
window
User Screens
For More Information On This Product,
Go to: www.freescale.com
Status, Meaning
Armed — bus analyzer is armed and waiting for a trigger
Disarmed — bus analyzer is disarmed
Continuous all — continuous trace, all cycles
Continuous events — continuous trace, events only
Counted all — counted trace, all cycles
Counted events — counted trace, events only
A+B+C+D — trigger on event A, B, C, or D
A+B>C+D — trigger on event A or B, then C or D
A>B>C!D — trigger on events A, B, and C, in order,
unless event D occurs
A>B>C>D — trigger on events A, B, C, and D, in order
Nth A+B+C+D — trigger on Nth event A, B, C, or D
Idle, Running, Stopped, Wait, or In Reset followed by
the reason for a status change
Resetting — Target system can reset emulating MCU
(blank) — Target system cannot reset emulating MCU
Resetout — RESET command resets emulating MCU
and the target system
(blank) — RESET command resets only the emulating
MCU
Logfile — Logging in progress
(blank) — Logging not in progress
Target pwr — Target system power is on
(blank) — Target system power is not detected
COMX:BBBBB — The host software is communicating
with the MMDS through port X, at BBBBB baud
Inst brkpt/Illegal Address — A breakpoint or illegal
address has been encountered and execution has
halted
Write protect — An attempt was made to write to
memory designated as ROM or is unused memory
space. Program counter will be at the next instruction
that would have been executed had the error not
occurred.
MMDS0508OM/D
MOTOROLA