Configuring The Platform Board - Freescale Semiconductor Motorola MMDS0508 Operation Manual

Installation

Configuring the Platform Board

NOTE:
22
Freescale Semiconductor, Inc.
Power Cord
Socket
Power Switch
9-Pin Serial
Connector
+5V Out
Figure 2. M68MMDS0508 Station Module (Left Side)
The MMDS platform board has four jumper headers, all located near the
front of the platform board. Jumper header J1 is for factory test.
Depending on the design of each emulation module, jumper headers J2,
J3, and J4 may control the voltage levels for ports A through D.
The factory configures the platform board correctly for virtually all users
before shipping the MMDS. These platform board jumpers should not be
reconfigured unless instructed to do so by an emulation module (EM)
user's manual.
Installation
For More Information On This Product,
Go to: www.freescale.com
Panel
MMDS0508OM/D
MOTOROLA