Cisco TelePresence IX5000 Installation Manual page 89

Installing the Camera and Light Panels
2
Attach the light panels.
xx) and the cable between the light bar and codec (already installed in the endpoint structure). Do not put
stress on the cable connection, as it can break the connection inside the light bar.
and fit the tabs on top of the light panel behind the tabs in the center horizontal crossbar. Do not place the light
bar tabs into the crossbar slots.
pillar. Visually center the light panel in the frame. DO NOT allow the panel to fall during this procedure.
a. Light panel
cable connector
a. Connect the cable connectors between the center light panel (part of 74-12235-
c. Swing the bottom of the light panel inward so it sits on the small shelf on the
b. Fit light bar tabs
behind the crossbar
slots - DO NOT place
in the crossbar slots
c. Rest on
Shelf
DO NOT put stress on the
cable at the light panel
b. Lift the panel into position
74-12235-xx
© 2015 Cisco Systems, Inc. All rights reserved.
Page 89