Cisco TelePresence IX5000 Installation Manual page 24

Installing the Cable Runner
2
a. Slide the cable runner base into position under the lower center frame.
(3x per cable runner bracket) using a 6mm T-handle hex driver. Place the hex driver through the access
holes in the frame beam as required.
both brackets are resting on the lower part of the runner (not on the ribs).
Page 24
© 2015 Cisco Systems, Inc. All rights reserved.
c. Lower the runner brackets through the cutouts in the runner until
a. Slide the cable runner into
position
b.
c. Lower the
brackets
b. Loosen 3x
screws on
each side
Loosen the 6x hex screws