Cisco TelePresence IX5000 Installation Manual page 116

Completing Installation of the First Row Table
8
Install the cable retractors into the table.
right-center table leg, and attach it using 4x M3x12mm screws 48-2091-xx.
for the left cable retractor using 4x M3x12mm screws.
for the cable retractor. Route the other presentation cable end through the cable runner to the Host CPU
codec.
Example shows right table leg
Page 116
© 2015 Cisco Systems, Inc. All rights reserved.
a. Place the retractor into the table from the right side of the
d. If you did not do so before, cut the two zip ties
4x 48-2091-xx
(installed from
other side)
Retractor: NEVER
cut this zip tie
Retractor: Cut these zip ties
if you did not cut them yet
b. Repeat on the left side