Cisco TelePresence IX5000 Installation Manual page 140

Installing the Second Row Table (IX5200 Only)
12
Determine the exit point for the cables (on the right or the left of the system). Bundle the cables into
the short round piece of the downspout 700-46612-xx from the left or right exit point. Connect
this piece to the long flat piece 700-46613-xx using 6x M4x10mm screws 69-2817-xx. Then connect the
assembled downspout to the far-right or far-left table leg using 3x M6x10mm screws 69-2803-xx. Note:
There are four holes in 700-46613-xx in which 700-46613-xx may be mounted. If the round piece is too
close to the floor, slide it up and use the top three holes. Tip: Install the downspout so that the tapered area
points toward the exit path for the cables. Note: If you use non-standard trenching between the endpoint
structure and the second row table, be sure that all cables can reach their intended electronic components
from one side of the table. If you have difficulty, two cable downspout sets are provided; you can route
cables from both sides of the table.
6x 69-2817-xx. Choose one of two
mounting points using the four holes in
700-46613-xx
3x 69-2803-xx (not shown, installed
from back of system)
700-46613-xx
Tapered edge points toward
exit path for cables
Page 140
© 2015 Cisco Systems, Inc. All rights reserved.
700-46612-xx