Installing the Optional 42-Inch Display
6
Level the display in relation to the fascia and the rest of the system. Rock back the display to separate the
two pieces (some force might be required). Loosen the four screws that hold the display to the display
bracket. The display pivots on the top right screw. Rotate the display and tighten the screws after the display
is level. Note the use of a "stubby" screwdriver. A Phillips driver and a ratcheting wrench may also be used.
Page 182
© 2015 Cisco Systems, Inc. All rights reserved.
Bracket pivots
on this screw
Stubby screwdriver
or Phillips driver with
ratcheting wrench