Cisco TelePresence IX5000 Installation Manual page 149

Installing the Outer Structure Panels and Trim
2a
Install the upper left and upper right cabinets.
horizontal cross bar, fitting the guide blocks of the cabinet into the slots in the cross bar. Make sure the
cabinet is as far to the outside as possible to allow installation of the trim joint.
xx into the right and center cabinet aluminum extrusions.
the guide pins on the side of the frame with the notches in the cabinet. Tip: Reach under the cabinets to feel
the notches in the cabinet that match with the guide pins in the frame. If the cabinet does not install correctly,
check the following areas: 1. The trim joint is connecting to the trim. 2. The guide pins in the frame align with the
notches in the cabinet. 3. The lap joint overlaps correctly between the side and center cabinets.
a. 800-41093-xx
a. Lower the right cabinet 800-41093-xx onto the
c. Slide the cabinet towards the center and engage
b. 700-43281-xx
Guide blocks
and slots
c.
Guide pins
b. Place the trim joint 700-43281-
Lap joint
Back of system
© 2015 Cisco Systems, Inc. All rights reserved.
Page 149