Cisco TelePresence IX5000 Installation Manual page 30

Installing the Pillars, Crossbars, and Rear Kick Plate/Toe Cap
4
Place the cardboard spacer (attached to the cable runner base) between the cable runner 700-42946-
xx and the rear kick plate 700-43100-xx. Level the rear kick plate with a spirit level. Verify that the kick
plate is at least 26mm (1 inch) above the highest point on the floor (measured on both the left or right side
ot the kick plate), then tighten the 2x M4 nuts you attached in Step 3. Save the spacer. You will use it when
you install the front kick plates.
Page 30
© 2015 Cisco Systems, Inc. All rights reserved.
Minimum 1"
(26 mm)
Cardboard spacer
2x 69-2793-xx
(viewed from
opposite side)
Minimum 1"
(26 mm)