Cisco TelePresence IX5000 Installation Manual page 152

Installing the Outer Structure Panels and Trim
3b
b. Loosen, but do not remove, the 4x black M4 X 16mm screws on the the lower cabinet sheet metal
brackets 800-41095-xx (2x screws for each side) so that there is some movement in the bracket.
Place the lower cabinets into position, fit the tab from the lower cabinet into the trim in the upper cabinet,
and connect the magnet on the cabinet to the endpoint structure. Place a plastic washer 69-2842-xx over 8x
black M4x12mm long screws 69-2797-xx, then install the screws with washer through the cabinet brackets
and into the endpoint structure. Do not use a power driver to tighten these screws. Tighten them so that
some movement of the cabinet is allowed but it can hold its
Loosen these 2x
screws in the cabinets
Page 152
© 2015 Cisco Systems, Inc. All rights reserved.
Table Top B
(700-42476-01)
Table Top C
(700-42478-01)
Table Top A
position.
(700-42477-01)
4x 69-2797-xx &
69-2842-xx
Connect magnet
Align tab with trim
to structure
c.