Cisco TelePresence IX5000 Installation Manual page 74

Installing and Cabling the Displays
1
CAUTION: Use care and wear gloves when mounting the displays - the vertical outer edge of the
displays has a sharp edge that can cause injury if the display slides through your hands.
NOTE: Display assembly is different than the TX or CTS immersive systems, please read this section
carefully before installation and follow all steps in the correct order.
Attach the Z-clips to the top of the displays. 700-46232-xx goes on the left side (when viewed from the
FRONT of the display) and 700-46233-xx goes on the right.
into the bracket finger-tight,
display, and d) tighten the 69-2625-xx screw with a #2 Phillips screwdriver.
Page 74
© 2015 Cisco Systems, Inc. All rights reserved.
b) peel off the adhesive tape backing on the bracket,
700-46233-xx
Install on this standoff (2nd from end)
1x 69-2625-xx
a) insert the 1x M4 X 6mm screw 69-2625-xx
c)
e) Repeat for all three displays.
1x 69-2625-xx
press the bracket to the
700-46232-xx