Cisco TelePresence IX5000 Installation Manual page 115

Completing Installation of the First Row Table
7
Install the presentation cups to the table tops.
the two inside table legs, 1 per table leg (do not place in the table leg yet).
presentation cable from the cable retractor through the presentation hole in the table and into the cup 800-
43264-xx. Connect the cup pieces using 6x M3 screws SR6213. Note: If there is not enough free play in the
cable, cut the two zip ties (and ONLY these zip ties) as shown in the illustration.
cup into the cup base in the Table Top Assembly.
SE2587. e. Repeat this procedure for the other cable cup.
6x SR6213
Top of table
Presentation hole in table
a. Lean the 2x cable retractors 800-42888-xx against
d. Secure the cup to the table using 4x M3 thumbscrews
Table Top B
800-42888-xx:
(700-42476-01)
Cut these zip ties
before installation
Table Top C
if there is not
(700-42478-01)
enough free play
to insert the
cable into the
presentation cup,
otherwise cut after
installation
b. Insert the triple-headed
c. Place the cable and the
Table Top A
(700-42477-01)
800-42888-xx: NEVER
cut this zip tie
Underside of table
4x SE2587
Page 115
© 2015 Cisco Systems, Inc. All rights reserved.