Cisco TelePresence IX5000 Installation Manual page 109

Completing Installation of the First Row Table
2
Prepare the microphone (mic) bar assemblies.
Do not throw away the small round microphone caps that attach to the center of the microphone bars.
Connect the the mini-DisplayPort Cables (two for each mic bar) to the connectors on the bottom of the mic bar
74-12199-xx. b. Connect the cables from the mute button to the mic bar.
upside down on the table.
assembly as shown.
red sticker on the underside - use these for the second row and DO NOT install these on the first row.
- Mini-DisplayPort cable for mic bar (6 total)
- Mute button cables (3 total)
d. Repeat this step for each mic bar.
NOTE FOR IX5200 SYSTEMS ONLY:
Mini-DisplayPort cable
a.
from table assembly (2
3x 74-12199-xx
a. Remove the mic bars and mic bar caps from the cartons.
e. Loop excess cable in the cable management
Three mic bars have a red plastic covering and have a
per mic bar)
IX5200 only: Turnaround mics (74-12552-xx) have a red label on
underside - use for second row only - DO NOT USE for first row
c. Gently rest the connected mic bar
Mute button to mic
b.
bar connection
© 2015 Cisco Systems, Inc. All rights reserved.
Page 109