Cisco TelePresence IX5000 Installation Manual page 65

Installing Endpoint Structure Cables
1
Install the cabling for the codecs, PDUs, lights, speakers, woofer, and (optionally) the 42-inch display
under the three main displays. The next few pages show the cable routing.
See the cable routing diagrams later in this section for the cabling connections. The color-coded
designators next to the cable ends
the connections on the electrical unit (codecs, PDUs, lights, speakers, and woofer). Be sure to connect
these on the correct side (for example, connect the side of the cable with the microphone icon to the
microphones, and connect the side of the cable with the MC icon to the Microphone Connectors.
Caution: Do not plug any additional equipment that is not part of the IX5000 or IX5200 system into the
PDUs.
NOTE: Since the light bars and camera are not yet installed, prepare these cables for installation using the
following procedure:
• Lay the light cables atop the speakers (left, right, and center atop the endpoint structure).
• Lay the camera cable directly in the center of the endpoint structure between the speakers.
Tip: If you need more Velcro straps, cut them crosswise to make double the amount of straps.
(L1, L2, L3, etc.) are shown on the previous page and correspond to
Page 65
© 2015 Cisco Systems, Inc. All rights reserved.