Cisco TelePresence IX5000 Installation Manual page 59

Starting Installation and Cabling of the Front Row Table
10
Connect and route the power and Ethernet cables for the table legs. Insert an extra power (jumper)
cable to the outside legs as shown in the picture on the left, and ensure that the inside legs have
room for the cable retractor (installed later) as shown by the yellow outline in the illustration on the right.
Note: The extra jumper cable is used in case of failure of the power module - you can replace the module
without removing the tabletops.
Outside table legs - insert extra jumper cable and route
behind power connector - note jumper connections
Inside table legs - make sure that cabling is
clear from yellow dotted area as shown. Inside
legs do NOT get an extra jumper cable.
Page 59
© 2015 Cisco Systems, Inc. All rights reserved.