Cisco TelePresence IX5000 Installation Manual page 110

Completing Installation of the First Row Table
6a
Prepare the Ethernet cables for the Touch 10 devices.
of the mic bar.
Touch 10 devices per segment) from the PoE switch in the front row table and pull them through the holes in
the center of the microphone bar until there is approximately 2 1/2 feet (76.2 cm) of free cable through the
mic bar hole. c. Attach the microphone bar plug (separately packaged with the mic bar) to the mic bar using
1x M4x12mm screw 69-2801-xx.
be pinched when the cosmetic panels are installed. Use Velcro straps as required.
additional Touch 10 devices, repeat steps a. though c. for the right and left mic bar; otherwise, attach the
cap to the left and right mic bars without inserting a cable.
a. Remove wrapping around
mic bar hole
c. 1x Mic bar cap & 1x
69-2801-xx screw
Page 110
© 2015 Cisco Systems, Inc. All rights reserved.
b. Take the Ethernet cable(s) (either one or two cables, depending on the number of
d. Ensure that the cables are routed under the table so that they will not
b.
cable (actual color is gray)
a. Remove the protective film around the center
2 1/2 feet of Ethernet
e. If your system uses
Note underside of mic bar cap.
Use these grooves to route two
Ethernet cables...
And use this groove for one cable.
One to two cables can be installed
per mic bar, for one or two Touch
10 devices per segment.
c. Check
routing under
the table