Gbas 0-5 Vdc Module Status Submenu Screens - Trane IntelliPak I Programming, Troubleshooting Manual

System Operating Status
MPM Return Plenum Pressure Input
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the
previously displayed screen.
3. Press the + (Plus) key while viewing any screen to add that
screen to the custom menu. Refer to the custom menu for the
creation and maintenance of customized menus.
4. Press the NEXT key until the following screen is displayed.
(if applicable)
End of Submenu (NEXT) to Enter STATUS
1. Press the NEXT key to leave the submenu and show following
screen.
2. Press PREVIOUS to page back through the submenu.

GBAS 0-5 VDC MODULE STATUS SUBMENU SCREENS

GBAS 0 - 5VDC Module Status Submenu
Press ENTER to View Data in This Submenu
1. Pressing the NEXT key will bypass this section.
GBAS 0-5VDC Module Input 1
Assigned:
1. Press the NEXT key to display GBAS 0-5 VDC inputs 2, 3 and 4.
2. Press the NEXT key until the following screen is displayed.
GBAS (0-5 VDC) Demand Limit Input Status
OPEN
1. Press the NEXT key until the following screen is displayed.
50
0.0 IWC
0.00 VDC
Not Assigned
Screen shown only if unit with
Return Fan installed
Possible Values: -0.7 to 3.5 IWC
Used With: All Units when GBAS 0-
5 VDC is installed
Used With: All Units when GBAS 0-
5 VDC is installed
Possible Values: Not Assigned,
Input=0.0-5 VDC Assignment,
Unocc Zone Cooling SETPOINT, Occ
Zone Heating SETPOINT, Unocc Zone
Heating SETPOINT, Supply Air
Cooling SETPOINT, Supply Air
Heating SETPOINT, Space Pressure
SETPOINT, SA Pressure SETPOINT,
Min OA Flow SETPOINT, MWU
SETPOINT, Econ Dry Bulb Enable
SETPOINT, Minimum Position
SETPOINT, Occ Dehumidification
Setpoint, Unocc Dehumidification
Setpoint , Supply Air Reheat
Setpoint, Occ Humidification
SETPOINT, Unocc Humidification
SETPOINT
Used With: All Units when GBAS 0-
5 VDC is installed
Possible Values: OPEN, CLOSED
RT-SVP04F-EN